Awhile back a camera module came out for the Raspberry Pi. So this evening I set up the camera, which is housed in a nice little case Chris printed on the 3D printer.

Setup was pretty easy. The instructions on the Raspberry Pi page are simple. So after a quick software upgrade I was up and running.

As you can see, the video quality isn't bad for a tiny, cheap camera.
Video streaming from the Raspberry Pi to my Windows desktop was a breeze. I used the sleeping cat as a test subject again.
And the quality of the still image captures is pretty decent as well.

All in all I'm pretty impressed!

0 comments:

Post a Comment