I practiced soldering a little on a soldering kit I had then moved onto the actual components. Despite having a fan going and the window open, it was still a little strong smelling. As you can see I tried to mitigate that with a painters mask, but of course that didn't do much.
Soon the component was assembled and I hooked it up to the Raspberry Pi to test.
As you can see, everything worked and I was able to get a temperature reading from a sensor I wired to the Pi Cobbler. Success!
The next item I had to solder was an Arduino Motor Shield. This little thing will allow me to construct a small robot. There were a lot more components for this project.
And thanks to a magnifying glass and some patience...
The whole thing was assembled in no time!
0 comments:
Post a Comment